How Hackers Kick Victims Off of Wireless Networks

Hello, my hackers Friends ! Today we’re going to be covering a little bit of Wi-Fi hacking. Specifically, we’re going to be learning how to kick other people off of wireless networks, even when we’re not connected to it ourselves! We’re going to be using an external wireless adapter for this, so if you don’t have one, I highly recommend getting one, as it is an essential piece of equipment for hacking Wi-Fi! The wireless adapter I’ll be using for this lesson is the Atheros Ar9271, which is capable of packet injection (injection is a very important feature to have for our wireless adapter). Now that we’ve got all that out of the way, let’s get started!

Step 1: Configure the Wireless Adapter for the Attack

If we’re going to use our wireless adapter for this attack, we’ll need to configure it to do so! First, let’s take an overview look at our current wireless adapter setup:

Now, for this demonstration attack, we’re going to connect our built-in wireless card (wlan0) to the target network. Then, we’ll use our external wireless adapter (wlan1) to kick ourselves off the network. Next, let’s put our external adapter into monitor mode:

First, we use ifconfig to set the interface down. Then, we use iwconfig to change it to monitor mode, then we’ll bring it right back up. Now, when we check the output of iwconfig is shows that our external adapter is in monitor mode. Now that we have our adapter configured for this attack, let’s get to it.

Step 2: Sniff for Target Networks

If we’re going to boot ourselves off a wireless network, we’ll need to identify what network we’re on first! For this, we’ll be using a tool called airodump-ng. This will allow us to view all the wireless networks in our area:

Step 3: Sniff for Victims on the Target Network

Alright, so we have a couple of networks in our vicinity. The network that our built-in adapter is on is NETGEAR89, so let’s do some sniffing specifically for that network. From this information here, we’re going to be using the BSSID and the channel number of the NETGEAR89 network. So, let’s just re-execute airodump-ng and pass it this information:

Now, once we execute this command, we should be able to see information regarding the clients connected to this wireless access point (WAP):

Alright, now that we have this information about the connected clients we can move on to the next part of the attack. (Note: in order for the next part of the attack to work, we need to keep airodump-ng running, so leave this terminal open. I’ve just minimized it to move it out of the way.)

Step 4: Inject Deauthentication Frames into the Target Network

Now that we have the information about the target network, and the clients on said network, we can finally perform our deauthentication attack and boot ourselves off. The tool we’ll be using to inject the deauth frames into the network is aireplay-ng. This is command we’ll use to start aireplay-ng:

Here we specify the deauth attack and tell aireplay-ng to inject only once. We then use the -a flag to give the BSSID of the target network. Ending the command, we specify the client to deauth by using the -c flag followed by the victim’s MAC address. Now, let’s execute this command and wait.

After the injection is finished, we should be able to take a look at our wireless adapters and see that we are no longer connected to a wireless network:

There we have it. After our deauth attack, we can see that our PCI (internal) wireless adapter has been disconnected from the wireless network, we did it! This is only the beginning of Wi-Fi hacking here on HackingLoops. In the near future, we’ll be attempting to build our own versions of the tools we used here, so we can develop a better understanding of how these tools works. When we build these tools, we’ll be using Scapy and Python, so if you haven’t read our articles on those topics, I recommend doing so!